LENCO DVP-733, Instruction Manual

Page: 16 / 140

16
GETTING STARTED
Using the Remote Control
To load a battery in the remote:
Pull in the direction of the arrow. 1.
Slide the compartment out. 2.
Place the battery in the compartment with the positive side ( + ) facing up. 3.
Push the compartment in to close. 4.
Point the remote at the remote sensor of the photo frame at a distance of no more than 15″ •
and at an angle no greater than 60 degrees.
Batteries will last for about one year under typical usage. •
Replace the batteries if the remote is no longer working. •
Do not spill water on the remote control. •
Do not use the remote control for other equipment at the same time. •
Remove the batteries if the remote control will not be in use for an extended period of time. •
See Power Connections section. .