F. Start and Stop Buttons – You will see two buttons next to the timer. When you turn on the unit,
the Stop button lights up red and the Start button stays dark. Press the Start button to begin the
session and it will light up green. Push the Start button again before the session times out to
start a new session of the same duration. Push the Stop button to end the session before the
timer runs out. Always stop the session before powering off the device.
G. Apply the Rope to the Treatment Area – Place the rope coiled with your chosen method on or
near the body so that it surrounds the source of pain identified in Step A. Start by holding the
rope far from the body. After you press the start button in Step H, you can slowly bring it closer
to the body until it touches or until each pulse is felt comfortably.
H. Start the Session – Press the Start button. You will hear a popping sound come through the
machine each pulse. Each pulse may produce a slight muscle contraction and tingling sensation.
The strength of the contraction depends on the number of wraps made on the treatment rope,
distance of the rope from your body, the size of the loop, the Intensity adjustment on the front
panel, and the muscle groups exposed. If you do not experience muscle contractions that is fine
because you are still receiving treatment.
I. Adjust the Intensity and Rep. Rate – There are two knobs on the front panel. One controls the
Intensity, which is the strength of each pulse. And the other controls the Repetition Rate, or
speed of each pulse. Turn the Rep Rate all the way up and focus on adjusting the Intensity.
Adjust the Intensity until the treatment is felt strongly but kept within the range of the user’s
comfort level. As the Intensity is turned up, the Rep Rate will automatically slow down. We
strongly recommend that you leave the Rep Rate dial set to maximum and only adjust the
Intensity dial.
J. On ‘Extra Pulses’ After the Session Ends – Sometimes after the timer runs out the machine will
make an additional pulse. The machine is discharging unused energy built up during the session.
This is normal and happens occasionally. After stopping a session, wait a moment to be sure
that any additional energy has safely discharged before powering the machine down and
removing the treatment accessory.
