10CH Essential Instructions R1.2
2022/11/05
13
Examples of the options available are shown in the pictures below.
On the main screen of the transmitter, you can scroll through the available telemetry screens using the roller.
The transmitter can record the telemetry data on the SD card for later review, a potentially very valuable feature
in the event of problems. This is set up using the File Settings item on the Telemetry screen.
For detail on all these capabilities and more, see
the separate document “Telemetry with
the Lemon RX 7 and 10
Channel Rec
eivers”.
Factory Reset the Receiver
A reset will cancel all programming and other settings, leaving the receiver in simple, unstabilized status. The
transmitter is not required for this operation.
1.
With the receiver ON, press and hold Button B and Button F simultaneously for about 6 seconds.
2.
Release the buttons when all receiver LEDs flash.
3.
Press Button C briefly. The receiver will flash for about 1 second, then reboot.
4.
Reset complete. No lights showing.
Note that Reset does not clear an existing bind.
Firmware Version
Lemon receivers are not user updatable, but if you need to contact Lemon
about a current telemetry receiver it will be useful to know the exact release
of the firmware.
When the receiver is powered on, the firmware identification is displayed
briefly as three numbers in the fields B, L, and R on the Flight Log screen. For
example, this receiver has firmware version 22 10 6.
10
The firmware identification is only shown for a few seconds, so the transmitter needs first to be set to the Flight
Log screen. Then the receiver can be turned off and back on to trigger the display.
10
A represents the RSSI value. Fields B, L, and R normally show 0, except when displaying the firmware identification.