E13
1. Press the Menu button.
2. Turn and press the Select dial or use the <Select> buttons on the remote control to choose
‘
Scan
’
.The number of stations found will be displayed during the autotune.
When the autotune has finished, tune to the last station that you were listening to. If the last station
you were listening to is no longer available, tune into the first station in the alphabetical list.
Manual tuning
To manually check the signal strength of a known channel:
1. Press and hold the Menu button to view the main menu.
2. Turn and press the Select dial to choose
‘
Manual tune
’
.
3. Turn and press the Select dial to choose the channel.
Dynamic range control
Dynamic Range Control (DRC) is used to make quieter sounds in a digital radio broadcast easier to
hear at low volume or in a noisy environment. Check with the broadcasters to find out if they use DRC.
To change the DRC settings:
1. Press and hold the Menu button to view the main menu.
2. Turn and press the Select dial to choose
‘
DRC
’
.
3. Turn and press the Select dial to choose between one of the following options:
DRC high: Applies maximum compression to the DRC level.
DRC low: Applies reduced compression to the DRC level.
DRC off: Removes DRC compression.
FM radio settings
Note: You can only see the FM radio settings when you have selected
‘
FM
’
as the radio source.
FM stereo option
You can choose between stereo or mono reception when listening to FM radio. Mono may improve
clarity where stereo signals are weak.
To change between Stereo or Mono reception:
1. Press and hold the Menu button to view the main menu.
2. Turn and press the Select dial to choose
‘
Audio Setting
’
.
3. Select between
‘
Stereo Allowed
’
or
‘
Forced Mono
’
.
FM scan
You can choose whether automatically stops at the next available FM station or the next available FM
station with a strong signal when scanning for an FM station. To change the FM scan setting:
1. Press and hold the Menu button to view the main menu.
2. Turn and press the Select dial to choose
‘
Scan Setting
’
.
3. Select between
‘
Strong Stations Only
’
or
‘
All Stations
’
Energy saving
Due to ErP stage 2 requirements and protect the environment, the unit will turn off to the standby
mode automatically once no music has been playing around 15 minutes except in AUX mode. When
the AUX mode is used for more than 4 hours, the unit will switch to standby mode. 10 minutes before
entering standby mode you will be notified with
“
AUTO-OFF
”
flashing on the display. To extend the
AUX mode you can press RANDOM.
When the unit is power off due to ErP, you can press the STANDBY button to turn on the unit again.