well charged 12V battery. Depending on the size of the battery, it can take up to a few
minutes to recharge your Booster.
Another way to recharge a Batteryless Start Booster would be to leave it connect-
ed for 10-15 seconds
maximum
to the engine/alternator of the vehicle after it has
started. The alternator will recharge it immediately. (Please make sure to remove the
clamps after 15 seconds max.)
Make sure to only use the supplied charger. Using a non-authorized charger will void
the warranty and can be dangerous. Batteries or Capacitors that are overcharged will
inflate and start producing gases, which may cause an explosion or a fire. That is why
we only recommend using the supplied charger in a well ventilated area.
4. OPERATING INSTRUCTIONS
Always wear safety equipment before trying to jump start your vehicle. Make sure the
area is well ventilated and that the terminals are clean.
Also make sure that your unit is fully charged before attempting to jump start.
If you have a 12/24V unit, make sure that the voltage selector switch is on “OFF” or
that the red voltage connector plug is unplugged. If you have a 12V (or 24V) unit with
ON\OFF switch, make sure it is turned OFF. Please also make sure that the cables
are not in the path of moving parts of the vehicle’s engine.
The battery terminal not connected to the frame should be connected first. The oth-
er terminal should be connected to the frame, far from the battery and the fuel line.
After the start, remove the frame connexion first, then the connexion from the battery
in the same order.
Please turn OFF the air conditioning, the radio and the lights before the jump start.
A.
BATTERY START BOOSTER
1.
Connect the positive (red) clamp to the positive terminal.
2.
Connect the negative (black) clamp to the frame of the vehicle (ground).
3.
If you have a 12/24V unit, choose the voltage with the voltage selector switch or
with the voltage connector plug 12V or 24V. If you have a 12V or 24V unit with
ON/OFF switch, turn it ON.
4.
Then start your engine and stay clear of the battery and the Start Booster
while jump-starting. Make sure that it cannot fall inside the engine compartment.
5.
Once started, first disconnect the black (negative) clamp, then place the
voltage selector switch on OFF; or unplug the voltage connecter plug from the
12/24V unit.
6.
Then disconnect the red (positive) clamp.
7.
Store both clamps immediately in their respective placing.
8.
Recharge the Jump Starter with the supplied automatic charger.
Important: Should the vehicle refuse to start within 10 seconds, have the Start
Booster cool down for 3 minutes before the next attempt. If it still doesn’t start,
09
