LEMAN SRU470, User Manual, Page: 35 / 47

3.0 Assembly
The machine is supplied partly assembled. Prior to
use, the following items have to be assembled;
working table, rip fence and crank handle.
WARNING! Use a 2,000kgs wrecker hang up this
bandsaw with Ring (Fig.1) to suitable place. To
ensure sufficient upright stability of this bandsaw
and safety, you need to bolt this bandsaw to floor on
M10 screw.
Fitting Working Table
With the help of another person, lift the working
table onto the trunnion.
Mount the working table to the trunnion using the
supplied (4) hex bolts and (4) washers (A--Fig. 2).
Using Hex socket screw, bushing, washer and
wingnut (B--Fig. 2) for the working table flatness.
Fitting Rip Fence
Install the rear fence rail to the table with (2)
M6-1.0 x 20 hex bolt and (2) flat washer M6 (Fig.3).
Install the front fence rail to the table with (4)
thumb screw and (4) flat washer M8 (Fig.3).
Make sure the end cap is locked into the rear fence
rail. Then set the fence on the front and rear rails.
Fitting Crank Handle
Attach the big crank handle (Fig.4) and small crank
handle (Fig.4) with 14mm and 10mm wrench
separately.
Ring
Fig.1
A B
Fig.2
Fig.3
Rear fence rail
Bolt/washer
Front fence rail
Thumb screw/washer
Fig.4
Big crank handle
Small crank handle
5
GB