LEMAN PRC016, Operation Manual, Page: 25 / 38

Operating Manual & Parts List
ASSEMBLY (CONTINUED)
Retaining Ring
Hex Head Bolts
Set Screw
Rack
Base
•
Slide retaining ring over column with beveled edge down.
Position ring against top of rack so that rack is in beveled edge
of ring. Secure ring with set screw.
•
Rotate table assembly around column. Adjust ring as necessary
to prevent binding of rack.
•
Attach crank handle onto worm gear shaft. Secure handle with
set screw, tighten screw on flat of worm gear shaft.
•
Insert table bracket locking handle into bracket and tighten to
secure bracket.
Retaining Ring
Locking Handle
Crank Handle
Figure 3
–
Mount Column Assembly to Base
MOUNT TABLE
MODELZQJ3116
Refer to Figures 3, 4 and 5.
•
Remove retaining ring by loosening set screw and also remove
rack.
•
Make sure worm gear is in the table bracket and engages pin-
ion teeth.
•
Place rack inside table bracket. Slide rack into the slot in the
bracket so that rack teeth engage the pinion gear in the bracket.
•
Slide table bracket assembly with rack over column. Place
bottom end of rack inside beveled edge of column flange. See
Figure 4.
Rack
Table Bracket
Assembly
Worm Gear
Figure 5
–
Attach Retaining Ring, Crank Handle and
Locking Handle
MODELZQJ3116A
Refer to Figure 3, 6, 7 and 8.
•
Remove retaining ring by loosening set screw and also remove
rack.
•
Make sure worm gear is in the table bracket and engages pin-
ion teeth.
•
Place rack inside table bracket with large, unmachined portion
of rack to the top. Slide rack onto the slot in the bracket so that
rack teeth engage the pinion gear in the bracket.
•
Slide table bracket assembly with rack over column. Place
bottom end of rack inside beveled edge of column flange. See
Figure 6, page 5.
Column Flange
Figure 4
–
Position Table Bracket Assembly on Column
4
EN