LELY Lely Discovery 90 SW, Operator'S Manual

Page: 115 / 150

5.4006.8501.0
B
Maintenance 6-17
Close-up
1. Use a suitable lifting or tilting tool to put the machine back onto its wheels.
2. Switch On the Machine (see page 5-3).
3. Start the Lely Control Application (see page 5-4).
4. Push .
During the calibration process you must not move the machine.
5. Push Yes to start the gyroscope calibration process.
6. Wait until a beep is heard (about 5 minutes) to confirm that the calibration is complete.
7. Drive the Machine to the Charging Station (see page 5-6).
8. Start the time path to put the machine into operation (see Start or Stop the Time Path on page 5-32).
6.3.10 Replace the Sliding Disc
Preparation
1. Manually drive the machine to a clean and quiet location (see Manually drive the Machine on page 5-
6).
2. Switch Off the Machine (see page 5-3).
Replace
Unexpected cow movement.
Risk of being crushed or trampled.
Block the cow traffic.
Heavy parts.
Risk of personal injury.
Use suitable lifting or tilting equipment.
1. Use a suitable lifting or tilting tool to lift the front of the machine and put the vehicle on its rear.
in n o vato rs in ag ric u ltu re