LELY HIBISCUS 425, Operator'S Manual, Page: 73 / 86

4.1059.8506.0
A
Maintenance 8-17
Figure 40. Replace the tine(s)
KEY:
1. Bolt - 2. Clamp block - 3. Cap - 4. Tine - 5. Nut
8.3.2 Replace the Tine Arm(s)
Requirements
•
Torque wrench
•
Loctite 243
•
Grease pump
Procedure
1. Take the rake out of operation (see page 6-12).
2. Remove the lynch pin from the lock pin (6) (see figure 41 on page
8-18).
3. Remove the lock pin from the tine arm.
4. Remove the tine arm with the tines from the tine arm shaft.
5. Remove the two bolts (3) of the tine arm clamp block (4) (see figure
41 on page 8-18).
6. Remove the two halves of the tine arm clamp block (4).
7. Remove the washer (5).
8. Remove the screw (9) of the cover plate.
9. Remove the cover plate (2) from the rotor.
10. Remove the three bolts, washers and nuts (1,10,11).