LELY 5.4001.0010.1, Manual

Page: 29 / 70

Chapter 2 - page 3
DISCOVERY manual 2
D-H002
.0
607E
N
2.1.3 Installing the charger unit on the cowshed floor
1) Fit the electrodes (5, figure 2 1 ) to the lower support (4) with
M8 bolts (4x).
2) Fix the floor column (1) to the shed floor with M10 bolts (8x -
not supplied). Make sure that the whole unit is level.
3) Fit the lower support (4), including the electrodes, into the
grooves on the floor column and tighten by hand ( figure 2 3 ).
Adjust the height of the support (4, figure 2 1 ) so that the
centre line of the lower electrode (measured from the
cowshed floor) is at 33 cm (
figure 2 3 ).
NOTE
• The electrodes can be bent a little with respect to each
other, meaning that the distance of 40 cm may no longer be
exact. Check the distance and adjust manually if required
(alignment).
4) Check the height of the upper electrode ( figure 2 3 ). This must
be at 40 cm (measured from the shed floor).
5) Tighten the bolts for the lower support (4).
6) Fit the battery charger (7) on the upper cover.
7) Fit the upper support (3). To make sure that there is a proper
overlap between the covers, the separation between the two
supports must be 50 cm.
8) Put the electrical wiring in place (red + and black -).
• Read through the safety instructions carefully before assembling and connecting the battery
charger. For more information see
chapter 2.1.5 'Installing the battery charger' .
9) Fit the lower cover (9) and then the upper cover (6).
Figure 2 3 Installation dimensions