Leitronic AG EasyAlarm EA-8 DPXM, Start-Up

Page: 19 / 40

6.9 Remote access by dialling-in
If the alarm unit is switched to ON you can dial in from distance as following:
6.9.1 Direct dialling-in (Profile P00,01,03,04)
1. Dial phone number where EasyAlarm® is connected.
6.9.2 Two-step dialling-in (Profile P02)
1. Dial phone number where EasyAlarm® is connected.
2. Let it ring two times and hang-up.
3. Re-dial after 20 seconds.
After the programmed ringing cycles

9.8.1 EasyAlarm® answers call and asks for PIN-Code to access.
After entering correct PIN-Code EasyAlarm® establishes service connection (speaker and microphone remain inactive to
maintain the privacy of the person in the cabin).
By sending touch-tone
1
you may switch to hands-free connection. Doing so the green lamp on the sub-communication
unit will be activated (EN81-70) and three rings will inform a person inside the cabin.
If no touch-tone command is entered the connection will be terminated after connection time-out of 2 minutes.
Notes:

If there are any unacknowledged alarms, their number will be announced and the cause of alarm of the last call. By
sending touch-tone
0
you can acknowledge these alarms and terminate connection.
 The number of ringing-cycles can be adjusted

9.8.1.
 If touch-tone
#
is send instead of the PIN-Code, the number of ringing cycles for next access will be increased by 5
i.e. to access a modem connected in parallel.

Adjust dialling-in sequence

9.8.2.
 If access should be in hands-free connection and/or without PIN-Code

9.8.3.
 If the PIN-Code is incorrect or not entered within 15 seconds, EasyAlarm® disconnects after
=> try again and enter correct PIN.
 PIN-Code is factory set to 0000. For safety reasons we recommend changing PIN-Code and program your individual
code according to the manual

5.5.
 During inactive waiting period (indicated by a permanently activated green LED you can dial-in directly.
17
to stop press
0
, to speak press
1
PIN-error, abort