5.4
How to select user language / record individual message
You may listen to or record new individual message as following:
1. Set function switch to PROG.
2. Enter sequence
**#
.
3. Select user language (optional entry): key
1
for DE,
2
for FR,
3
for GB,
4
for IT.
available languages see label on the back side of alarm unit.
4. Start recording using key
*
, record new text and stop with
#
(max duration is 12 seconds).
5. Set function switch to OFF.
Note:
Repeat step 4 until you are satisfied with your recording.
5.4.1
Remote recording of individual message during telephone connection
1. Enter touch-tone sequence
**##
.
2. Select user language (optional entry): key: Touch-tone 1 for DE, 2 for FR, 3 for GB, 4 for IT.
3. Send
*
to start recording, record new text (max duration is 12 seconds) and wait until new recording is reproduced.
4. Wait unit . New recording is done.
Note:
Enabled/disabled remote programming
5.5
How to program PIN-Code (Identification)
You can change remote access PIN-Code as follows:
1. Set function switch to PROG.
2. Press
#
.
to lock further programming
5.5.1 enter
*
.
3. Enter PIN-Code (4 to 7 digits).
4. Press
#
.
5. Re-enter PIN-Code for confirmation.
6. Press
#
.
In case of a incorrect programming you hear and the old PIN-Code remains stored.
7. Set function switch to OFF.
Notes:
PIN-Code must contain 4 (min) to 7 (max) digits.
PIN-Code is factory set to 0000. For safety reason we recommend to program your own PIN-Code.
During telephone connection you may playback PIN-Code by sending touch-tone
#
.
This function may be used to identify alarm unit, i.e. when using commission number as PIN-Code.
5.5.1
Lock program mode
If you initiated programming new PIN-Code with key
*
the program mode is locked unless you unlock by re-entering PIN-
Code. This feature prevents from unintentional reprogramming during operation.
5.5.2
Unlock program mode
Having the programming blocked as described under 5.5.1 you can unlock as follows:
1. Set function switch to PROG.
2. Enter PIN-Code followed by
#
.
By entering correct PIN-Code you will hear a confirmation beep, otherwise message .
3. Set function switch to OFF.
12
Abort
Error
Programming deactivated: PIN
Error
to modify press
*
, to stop
#
...
...
...
...
...
to modify press
*
, to stop
#
