6
4. SETUP
4.1 Operation with Plug&Protect motion sensor (EasyAlarm COMBI)
4.1.1 Safety instructions
Function switch
must be shifted to OFF and telephone-cord must be disconnected before any wiring work is
done on the AC-adapter or Motion sensor cable.
All the electrical connections have to be potential free. Observe the regulation according to EN60950.
All contacts have to be protected against any body contact
Do not plug the phone cable (5) into the EXT/
≂
-jack, only into
-line jack of
alarm unit (1)!
4.1.2 Mounting PIR-motion sensor
Choose the mounting location after careful consideration of the area to be protected.
The motion detector should be located so that an intruder will cross the infrared beam
pattern. If used to verify presence, a regular used room should be detected. Figure
shows the different infrared beam patterns at a typical mounting height of 2.5m.
Notes:
Do not mount detector towards direct sunlight or near to heat sources.
Do not mount detector behind items like glass or curtains because the infrared-
beam cannot penetrate them.
Keep away pets like cats or dogs from the protected area.
Do not protect the same area by more then one detector, because they can interfere.
4.1.3 Installation
1.
Slide
function switch
to OFF
2.
Insert 9V battery
into compartment on rear side of alarm unit
Please note: The telephone cord must be disconnected before opening the battery compartment because otherwise
you can get in contact with the telecommunication voltage!
3.
Connect the AC-adapter cable
into one of the EXT/
≂
-ports of the alarm unit
4.
Mount the motion detector
and connect the cable to the other EXT/
≂
-port of the alarm unit
6.
Plug AC-adapter to main socket
Test and adjust motion detector
Details according to section 4.1.6
WALK-Test:
Wait at least two minutes after power-up for the motion detector to be stabilised. After this time, check the
entire area by observing the LED. Adjust swivel if necessary.
Telephone connection
7.
Plug enclosed telephone-cord
into
-Line-Jack
of alarm unit and connect it with the telephone network
If you share line with modem/telephone please proceed according to section 10.6
Program calling number(s)
Details according to section 6.1
8.
Slide
function switch
to PROG
9.
Enter
* * <n>
(selected calling number: Standard
n
= 1..9)
Corresponding calling number will be announced, followed by message “to modify press star“
10. Press
*
and enter calling number
11. Slide
function switch
to OFF
2
1
4
3