Leitronic AG EA-8-WRL868, Use Instruction, Page: 5 / 40

5
3. SET VIEW / FUNCTION ELEMENTS
1 .
Function switch
Position Information
OFF Device is switched off
PROG Programming mode: Entering of calling numbers, calling number sequence, PIN-Code …
ON Device is in supervision mode
2 .
Selection switch
Position Monitoring functions in armed state ( Function switch on position ON)
I Part set (present) => Alarm is triggered by radio sensor other than internal type plus wired sensors
Noise monitor and internal radio sensors is inactive.
II Set (absent) => Alarm is triggered by all radio sensor plus wired sensors
Noise monitor is inactive.
III Set (absent) => Alarm is triggered by all radio sensor plus wired sensors
Noise monitor is activate with highest sensitivity
Note: Emergency call / Panic / Smoke / Technical / 24h-sensors are enabled all the time, independent
from the position of the function switch or arm/disarm-state.
3 .
Keypad
When function switch is on position PROG, you can enter the calling numbers or do further programming. If
function switch is on position ON pressing any key will start a test call .
Keys are marked with 1 2 3 4 5 6 7 8 9 * 0 # . in the following sections.
4 .
Loudspeaker
The integrated loudspeaker is used for voice guidance during the programming as well as for hands-free
communication during
phone connection .
5 .
Microphone
Is used during hands-free connection active. Case is noise monitor switch on for the room noise monitoring.
6 .
LED
Status of LED Operation mode
Green Waiting period
Green brief flashing every 4 seconds, also if acoustical
monitoring is active by exceed set noise level Supervision mode activated
Green is on and off for 4 seconds alternatively Supervision mode deactivated
Orange Phone connection
7 .
Battery compartment
The 9V-battery is used as a backup during power failure. Please note: The telephone cord
must be disconnected before opening the battery compartment because otherwise you
can get in contact with the telecommunication voltage!
8 .
Telephone jack (

-LINE)
The plug must be locked in the jack to disconnect press pawl.
9 .
External ports (
EXT/≂)
for accessories and power supply.
6
1
5
4
3
2
-L
IN
E

EX
T/
~
7
9
8