21
6.10Dialling-in (check call)
If the alarm unit is switched to ON you can dial in from any telephone set as follows:
1. Dial phone number of the
2. Let it ring for two ringing cycles and disconnect (hang up)
3. Redial after 20 seconds =>
answers call after two ringing cycles and waits for the PIN-Code
After entering the correct PIN-Code
establishes a
listening-in connection
Announcement „to stop press 0, to speak press 1“
If no
tone-dialling command
is entered, the
phone connection
will be terminated after two minutes
connection
time-out
. The supervised person can also terminate the phone connection by pressing the emergency button.
Important: In case that there are unconfirmed alarms, the quantity as well as the last reason of the alarm will be
announced! An unacknowledged alarm will be confirmed by entering DTMF 0 !
Notes:
The two-step dialling in procedure is for security reasons to avoid detecting of the alarm unit coincidently
by an unknown caller. Direct dialling in as well as other number of ringing cycles can be selected (
section 9.7)
If the PIN-code is incorrect or not entered within 15 seconds,
disconnects after the
announcement „PIN error, abort“ => try again and enter correct PIN.
PIN-code is factory set to 9797. For safety reasons we recommend changing PIN-code and program your
individual code according to the manual.
If a successful dialling-in should be signalled with five gong-signals and directly establish hand free
connection,
can be programmed according section 9.7.3.
6.11Answering an incoming call
An incoming call, signalled by a parallel-connected phone, can be answered as follows (
ON):
6.11.1 ..by pressing the radio - emergency button
a
hands-free connection
is established => Disconnect by pressing the emergency button once again.
6.11.2 ..by pressing any key of the alarm unit
a
hands-free connection
is established => Disconnect by pressing key
0
.
Summary of Contents for EA-8-WRL868
Page 39: ...39...