WARNING!
The charger can get very hot
while charging. Always keep it away from
material which can catch fire. Do not cover
charger. If there are any signs of smell,
smoke or melted plastic or unusual noises,
immediately disconnect charger from power
socket and do not use charger again. Always
attend charger during charging. For safety
reasons, keep away from water, moisture,
children
and
pets.
Keep
away
from
individuals with impaired sensory or mental
capabilities,
lack
of
experience
and
knowledge unless they are supervised by a
caretaker. Follow instructions contained on
the label of the charger. Do not use if power
cord is damaged. Dispose of according to
your local laws.
Figure B7: Charging the battery (Illustration)
Connect the
power cord (5) of the charger
firmly to the
power socket on the
charger (4).
Remove the
small rubber dust cover (1),
then connect the
charger
output cable (2)
to the
battery input socket (1)
on the battery. The LAST step is
to connect the
power chord (5)
to with the
wall socket plug (6)
to the power
point (AC, 100-224 Volt, 50/60Hz). After charging cover the battery input
socket with the rubber dust cover (1). Charger (3), battery (7).
WARNING
! To prevent electric shock connect
power cord (5)
to
wall socket (6)
as LAST step. Do not open charger due to risk of high voltage shock. Use
indoors only. Only charge original battery. Do not charge other types of
batteries. The charger must not be used Voltage is detected automatically. Do
not yank cables. Pull on plugs, not on cables.
After charging, disconnect
wall socket plug (6)
first.
Charging the battery
•
The battery can be charged while connected to the bike or off the bike.
•
Turn OFF the bike before charging.
•
Charging temperature between 10
℃
(50 °F ) and 30
℃
(86 °F).
•
During charging the temperature may increase to about 50
℃
(122 °F).
•
Stop charging battery if it gets unusually hot and contact customer
service. Charge undercover in dry area.
•
Only use original supplied charger to avoid overheating, bursting or
ignition.
•
The chargers are smart chargers, which means they will automatically
stop charging when the battery is full.
•
The battery takes about 5-7 hours to charge if
It’s
completely discharged.
•
At first charge, it can take longer since battery pack is balancing.
•
If battery does not fully charge within 8 hours, disconnect charger and
contact customer service.
•
If
it’s
not fully discharged it will take less time to charge.
•
It is recommended to switch the battery OFF while charging.
•
Disconnect charger after charging. Unplug charger from electricity grid if
not in use.
Lights on Charger:
•
If there are TWO LIGHTS on the
charger. BOTH LIGHTS RED: Charging.
ONE LIGHT GREEN and ONE LIGHT RED:
Fully charged or not connected.
•
If there is ONE LIGHT on the charger:
RED: Charging. GREEN: Fully charged.
1
2
3 4
5 6 7
Figure B6
: Location of the
battery
input socket (8)
underneath the
seat
(10).
Use
dust cap (9)
to cover input
socket after charging is complete.
Refer to Figure B7 for details.
10
8
9
© Leitner Pty Ltd 2020
14