Leisure Unity 2020, Owner'S Manual

Page: 111 / 145

WATER AND PLUMBING SYSTEM UNITY MOTORHOME
110
DISCONNECTING THE CITY WATER SUPPLY
1. Turn off the city water supply.
2. Relieve the water pressure in the line by opening a
faucet in the motorhome.
3. Disconnect the hose from the city water connection
1
.
4. Replace the protective plug over the city water
connection
1
.
4
1
2
3
FILLING THE FRESH WATER TANK
CITY WATER
1. Connect the water hose to the city water connection
.
1
2. Turn the water fill selector valve
2
to water tank
fill .
3
3. Turn on the city water supply.
4. Depress and hold the fresh water tank level switch
5
to show the percent-full level on the LED display
6
. Once the fresh water level reads full on the LED
display, turn off the city water supply.
6
10
5
7
5. Turn the water selector valve
2
to the city water
position
4
.
6. Turn on the water pump switch
7
.
7. Slowly open the cold water tap until the water runs
smoothly. Repeat with the hot water taps.
ᘐ
NOTICE
Always turn off the water pump switch
7
if
leaving the motorhome unattended for an
extended period of time and when driving to
prevent excessive damage and battery discharge
in the event of a leak.
POTABLE WATER
When a city water supply connection is not available,
fill the fresh water tank using the following procedure:
1. Fill a suitable water container with potable water.
2. Place the suction hose
8
attached to the winterize
by-pass valve into potable water container.
NOTE: The winterize by-pass valve
9
is located in the
exterior utility center.
9
8
3. Turn the winterize by-pass valve
9
to “WINTERIZE”
and water fill selector valve
2
to water tank fill
3
.
4. Turn on the water pump switch
7
on the system
monitor panel.
5. Depress and hold the fresh water tank level switch
5
to show the percent-full level on the LED display
6
. Once the fresh water level reads full on the LED
display, turn off the water pump.
6. Turn the winterize by-pass valve
9
to “NORMAL
FLOW” and the water fill selector valve
2
to city
water
4
.