Leisure Freestyle Series, Owner'S Manual

Page: 9 / 83

Leisure Manufacturing 2016 Owner’s Manual
DOC: LM-M-B-16
9
YOUR FILTER – REMOVAL & REPLACEMENT
Our various spa models use different filter systems depending on the spa design. Identify which filter
system is in your spa and check (
√
) it off for future reference.
“TELEWEIR” SKIM FILTER
Single cartridge mounted vertically 50 sq ft, 14 ½” (36.8cm) high (part #PWW50L)
1. Shut off your spa at the Ground Fault Circuit
Interrupter (GFCI) or Residual Current
Detector (RCD).
2. Lift the floating weir and filter sleeve straight
up above the filter body to remove.
3. Use the cartridge handle to thread the
cartridge out of the filter body.
4. Examine, clean, rotate or replace the
cartridge as necessary.
5. Hold the filter sleeve and twist weir top to
remove weir and allow basket debris to be
dumped out.
6. Reverse the procedure to install new or
cleaned cartridges.
ELITE TELESCOPING WEIR FILTER
Single cartridge, vertically mounted, 75 sq. ft. 14 13/16”(37.6cm) high (part #PLBS75)
1. Shut off your spa at the Ground Fault Circuit
Interrupter(GFCI) or Residual Current
Detector(RCD)
2. Use the raised tabs on the outer ring to turn
the ring and 2 piece weir assembly counter
clockwise until it releases form the filter
body. Remove and set aside.
3. Remove the debris basket by grasping the
inner tab. Dump any debris and set aside.
4. Pull cartridge straight up and out of the filter
body.
5. Examine, clean, rotate or replace the
cartridge as necessary.
6. Reverse the procedure to install new or
cleaned cartridge.