Leisure Works 1610636-1, Owner'S Manual

Page: 19 / 26

18
TREADBELT ADJUSTMENT
The treadbelt has been factory pre-adjusted, however
if during the operation:
Treadbelt slips during use if the treadbelt is too loose :
a) Tighten both rear roller adjusting bolts 1/4 turn
clockwise using allen wrench.
Treadbelt shifts too far to the right
a) Set the treadmill speed to 3.5 M.P.H.
b) Tighten the right adjusting bolt a 1/4 turn clockwise
using allen wrench.
c) Wait 15 seconds: if no change; turn the left adjusting
bolt a 1/4 turn counter-clockwise using allen
wrench.
d) Repeat steps b and c until belt is centered
Treadbelt shifts too far to the left
a) Set the treadmill speed to 3.5 M.P.H.
b) Tighten the left adjusting bolt a 1/4 turn clockwise
using allen wrench.
c) Wait 15 seconds: if no change; turn the right adjusting
bolt a 1/4 turn counter-clockwise using allen
wrench.
d) Repeat steps b and c until belt is centered
IMPORTANT
DO NOT OVERTIGHTEN TREADBELT
If treadbelt is over-tightened, edges of treadbelt will begin to curl
CAUTION!!
DO NOT ALLOW ANYONE TO
WALK ON TREADBELT WHILE YOU ARE
ADJUSTING.
1/4 TURN
1/4 TURN
1/4 TURN
If TREADMILL
slips during use.
too far to RIGHT.
If TREADMILL is
If TREADMILL is
too far to LFFT.
If Treadbelt slips during use.
If Treadbelt shifts too far to the right
.
If Treadbelt shifts too far to the left