Leisure Golf Quantum Slim Line, User Manual

Page: 10 / 18

Struc
tur
e
18
Installing the wheels, handlebar and battery
1. Take the axle in your hand and connect it to the front part. Slide the front
part up to the pin in the opening of the lateral axle.
Press the stainless steel pin into the frame and push the front part com-
pletely into the lateral axle. Turn the two parts together so that the pin can
engage into the hole.
2. Take the rear wheels and install them on the lateral axle as described below.
Danger: Pay attention to the running direction of the rear wheels. The profile
must point in the same direction as the front wheel profile.
- Press the pin on the rim.
- Slide the wheels onto the first groove on the axle. This is the freewheel posi-
tion (for manual pushing).
- Push the wheel to the final position on the axle and engage. This is the posi-
tion for driving.
Important: If the wheel is not in the drive position, there is no propulsion of
the device.
3. Now connect the vertical bar with the lateral axle. Proceed in the same way
as above.
4. With the side knob, you can adjust the handle height and ‘adjust’ the upper
bag holder individually to your bag size. Then tighten the lateral fixing screw.
5. Attach the battery to the front frame with the two Velcro straps and connect
the battery to the battery connector on the golf trolley. The LED on the control
panel will flash blue.
The Quantum optionally has a battery basket, alternatively the battery can
storage with an extension cable in the bag.
19
Adjusting the front wheel/going forward
With each trolley, the factory preset is straight travel.
Nevertheless, it may be necessary to readjust the barrel.
1. Loosen the cap nut one or two turns.
2. If the device is pulling to the left, unscrew the front grub screw and
screw in the rear grub screw.
3. If the device is pulling to the right, unscrew the rear grub screw and
screw in the front grub screw.
4. Then tighten the cap nut again.
5. You may have to readjust the setting with a second pass.
Dismantling procedure
1. Take the supplied socket wrench and press the spring button into the
frame. Turn the rod slightly so that the knob cannot spring back and pull the
linkage apart.
2. Repeat the same steps you have with the rod that
leads to the front wheel. By pressing and slightly
turning the linkage, the lock can be easily released.
3. Pull the wheels off the axle by pressing the pin on
the rim.
If you have ordered the trolley bag, you can optimally
stow all components in the bag.
The Quantum can be folded in addition to the disas-
sembly, easy and fast. To do this, release the handle height adjustment and fold
down the upper bag holder. The vertical rod can be folded forward, the front rod can
be rotated by pressing the locking pin by 90 ° to obtain an even flatter pack size. The
rear wheels should be removed for storage in the optional trolleybag
Front grub screw
Rear grub screw
Grub screw
Cap nut