Leister EXAMO 300F, Operating Instructions Manual

Page: 20 / 146

20
• Speed: Test speed in mm/min.
• Initial Length: Jaw spacing in mm, which is automatically adjusted by the equipment when pressing the
key or .
The jaw spacing can be corrected at any time with the key or .
The absolute position of the
sliding carriage (12) (jaw spacing) appears on the display (4) .
• Initial Tension: Level of initial tension. When the set initial tension is achieved, the evaluation of the tensile
test starts. If the initial tension is set to O N , the test evaluation can be started by pressing the Start key.
• Exit menu by pushing key
• When setting the initial length, the force display may show the value
≠
0. Reason: Influence of temperature on
the equipment and/or force on the clamping jaws (11) which are close to the housing of the drive motor
and circuit board (15).
• When starting the test, the force values are reset to 0.
Version with USB port has more menu items (see operation of USB port).
• Open storage case
• Connect enclosed power
cable to socket (1) .
• Connect the machine to the line/mains
• Pull out
clamping lever (9) un till it is locked
• Turn-on main switch (2)
– Position of sliding carriage is not at spacer (13)
–
Press <<, for Initialize appears on
display (4)
– Push key ,
Wait for Initialize appears on
display (4)
and sliding carriage (12) moves to spacer (13) .
– Display (4) shows standard mode
– Position of sliding carriage is not at spacer (13)
– Display (4) shows standard mode
Set Speed Set Initial Length Set Initial Tension
• Set the test parameters using the following keys:
Readiness for working
Test parameter
SET
SET
SET
–
–
SET
+ – + –
+
– +
–
+