Page 4 of 7
2007-09-10
SIGNAL WIRING AND PRO-BUS INSTALLATION INSTRUCTIONS
Start
Connect the following to your MINI-T-NET:
●
Input (source) equipment video cables (
A
)
●
Input (source) equipment audio cables (
B
)
NOTE:
If using, connect fallback source audio/
video cables to MINI-T-NET input 8.
●
Output (destination) equipment video cable (
C
)
●
Output (destination) equipment audio cable (
D
)
Connect one end of an RJ-11 cable to
Event Controller’s PRO-BUS output (
E
)
and the other cable end into the
input
of a
PRO-BUS interface.
Using attached device cable, connect
PRO-BUS interface to VCR/DVD player.
Connect an RJ-11
cable from the
output
of the first PRO-BUS
to
input
of another
PRO-BUS.
Set the DIP switches on each PRO-BUS
(see instructions included with PRO-BUS).
DIP Switches
End
Yes
No
Will MINI-T-NET be used for
device control?
Is there another VCR/DVD player
connected to MINI-T-NET?
Yes
No
NOTE:
Refer to “Illustration 1, MINI-T-NET Typical Playback System Diagram,” in the “Overview of MINI-T-NET Wiring
Connections” section of this quick guide and the illustrations on this page.
Rear View of MINI-T-NET
A
B
C
D
E
G
F
Connect power supply
(
F
) to MINI-T-NET and
plug Event Controller
into AC outlet.
Configure MINI-T-NET for
Ethernet network access (
G
).
See the “Ethernet Network
Configuration Instructions” section
of this quick guide.
End
Connect power supply
(
F
) to MINI-T-NET and
plug Event Controller
into AC outlet.
Configure MINI-T-NET for
Ethernet network access (
G
).
See the “Ethernet Network
Configuration Instructions” section
of this quick guide.
MINI-T-NET
Source
Equipment
PRO-BUS
Interfaces
PRO-BUS Interface Connections