Page 6
2018-08-07
LABvault-HD
System Installation
NOTES:
• The illustrations for the following examples show the terminal blocks in vertical positions. When
connected to the rear panel, the blocks are horizontal with the AES terminals on each block
rotated toward the “SDI IN” BNC video input.
• The LABvault-HD supports an audio wiring gauge range of 18 (maximum) to 28 (minimum) AWG.
a. Prepare your audio wiring for connection to the terminal
blocks by stripping approximately a 1/4 inch of shield
off the end of each wire. Twist each wire’s individual
strands together to prevent separation (see illustration
at right for example).
b. Perform the following steps for the LABvault-HD audio
record input and playback output:
i.
With your fingers, gently grasp the desired terminal
block on the LABvault-HD’s rear panel and pull to
separate the block from the player/recorder.
ii. Secure each of your prepared audio wires in their
appropriate terminals as follows, referring to the table
below for each wire’s placement on the terminal block:
NOTE:
The AES audio configuration uses only one of either common grounds.
Example of Wire Prepared for a LABvault-HD Terminal Block
AES
Terminal Block Configuration
Two-Channel Analog
Terminal Block Configuration
Terminal Block Wiring Configurations and Examples
Terminals
