Leica IP S, Instructions For Use Manual

Page: 28 / 78

28 Version 2.0, Revision I
Instrument Setup
4
1 Magazine loading help 14 0601 35979
1 Cartridge kit, 280 ml 14 0601 43506
1 Ink cartridge 14 0601 52658
1 Cleaning swabs, pack 14 0601 39637
1 Replacement plate 14 0601 40162
4.4 Installing the manual unload station
Fig. 12
1
2
3
4
5
3
6
7
8
9
The unload station supplied consists of:
• Unload station ( → "Fig. 12- 1 ")
• Screening plate (
→
"Fig. 12- 2 ")
• Collar screws (3 pcs.) ( → "Fig. 12- 3 ")
• Slotted screws with washers (2 pcs.) ( → "Fig. 12- 4 ")
Install as follows ( → "Fig. 12") :
1. Open lid (
→
"Fig. 12- 6 ") .
2. There are 5 threaded holes (2 x (
→
"Fig. 12- 7 ") and 3 x (
→
"Fig. 12- 8 ") ) in the installation
surface located below the reflector.
3. With a screwdriver, insert 3 collar screws ( → "Fig. 12- 3 ") in tapped holes ( → "Fig. 12- 8 ") as far
as they will go.
4. Then, fasten cover ( → "Fig. 12- 2 ") in tapped holes ( → "Fig. 12- 7 ") using the two slotted screws
and washers ( → "Fig. 12- 4 ") .