Leica DISTO
TM
D110 812794c
8
EN
Message Codes
If the message
Error
does not disappear
after switching on the device repeatedly,
contact the dealer.
If the message
InFo
appears with a number,
press the Clear button and observe the
following instructions:
Care
•
Clean the device with a damp, soft cloth.
•
Never immerse the device in water.
•
Never use aggressive cleaning agents or
solvents.
Disposal
CAUTION
Flat batteries must not be disposed of with
household waste. Care for the environment
and take them to the collection points
provided in accordance with national or local
regulations.
The product must not be disposed with
household waste.
Dispose of the product appropriately
in accordance with the national regu-
lations in force in your country.
Adhere to the national and country specific
regulations.
Product specific treatment and waste
management can be downloaded from our
homepage.
Warranty
Lifetime Manufacturer's Warranty
Warranty coverage for the entire usage time
of the product according to Leica Geosys-
tems International Limited Warranty. Free of
charge repair or replacement for all products
that suffer defects as a result of faults in mate-
rials or manufacturing, for the entire life of
the product.
3 Years no Cost
Guaranteed service should the product
become defective and require servicing
under normal conditions of use, as described
in the user manual, at no additional charge.
To receive the "3 years no cost" period, the
product must be registered at www.leica-
geosystems.com/registration within 8 weeks
of the purchase date. If the product is not
registered, a "2 years no cost" period applies.
No.
Cause
Correction
204
Calculation error
Perform measurement
again.
240
Data transfer error
Repeat procedure.
252
Temperature too high
Let device cool down.
253
Temperature too low
Warm device up.
254
Battery voltage too low
for measurements
Change batteries.
255
Received signal too
weak, measuring time
too long
Change target surface
(e.g. white paper).
256
Received signal too high
Change target surface
(e.g. white paper).
257
Too much background
light
Shadow target area.
258
Measurement outside of
measuring range
Correct range.
260
Laser beam interrupted
Repeat measurement.
