Leica BIOSYSTEMS HistoCore BIOCUT, Instructions For Use Manual

Page: 29 / 90

29 HistoCore BIOCUT
Setting up the instrument
4
8
9
Fig. 8
5
6
7
• Take out the fixing module (
→
"Fig. 8- 5 ") . To do
so, hold it by the top edge of the module and in
the recessed grip ( → "Fig. 8- 6 ") and pull it out by
pulling upwards.
• Remove the outer carton wall (
→
"Fig. 8- 7 ") .
• Lift the instrument (
→
"Fig. 8- 8 ") by holding it by
the base plate at the front (
→
"Fig. 9- 11 ") and
under the instrument on the back (
→
"Fig. 9- 12 ")
and lift it out of the formed cushion (
→
"Fig.
8- 9 ") . (The instrument illustration is provided as
an example only.)
Fig. 9
10
11
12
• Place the instrument on a stable laboratory
table. The two sliding elements (
→
"Fig. 9- 10 ")
located on the rear of the base plate make it
easier to move the instrument on the table.
• To move the instrument, hold it by the front of
the base plate (
→
"Fig. 9- 11 ") , lift it up gently and
slide it on its slides.
4.4 Assembling the handwheel
Tip
The handwheel has to be assembled before attempting to use the instrument. The necessary parts
and tools can be found in the tool kit supplied in the delivery.