Leica BIOSYSTEMS CM3600 XP, Instructions For Use Manual

Page: 37 / 86

37
Leica CM3600 XP
Software
6
3 Manual • Clicking on this button switches the instrument to manual mode.
• When activated, the button will light up in green.
4 Start/Stop • This button can only be activated in automatic mode, where it starts or stops the
section program.
• When activated the Start/Stop and Automatic buttons will light up in green.
6.4.10 Cutting window
1 3
2
4 5
Fig. 26
Displays the left (
→
Fig. 26- 1 ) and right (
→
Fig. 26- 2 ) block edges graphically represented by blue lines.
They indicate the maximum horizontal stroke of the microtome sledge on a scale of 0 - 500 mm.
Displays the current position of the microtome sledge (
→
Fig. 26- 3 ) . The sledge position is graphically
displayed by the green line. Clicking on the Actual position display changes the setting.
The icons on the left and right side of the scale (
→
Fig. 26- 4 ) and (
→
Fig. 26- 5 ) are used for adjusting
the left and/or right block half to the value of the current microtome sledge position according to the
display.
Left block edge button (
→
Fig. 26- 4 )
Clicking here opens up an entry window. The value to where the microtome sledge can be manually
adjusted on a scale of 0 - 500 mm for the left limit position can be set here.
Right block edge button ( → Fig. 26- 5 )
Clicking here opens up an entry window. The value to where the microtome sledge can be manually
adjusted on a scale of 0 - 450 mm for the right limit position can be set here.
6.5 Parameter settings
Clicking on Parameter settings icon opens the parameter settings window.