43
_________________________________________________________________________________
9.14 Boom transport support sensors
The lower transport support sensor S10 is located in the rear side of the chassis behind a cover
(Figure 30 (1)).
When the 1
st
boom is on the transport support:
-
Sensor face should face the narrowed section of the pin.
-
The led lights in the sensor MUST NOT BE ON.
When the 1st boom is lifted from the support:
-
The led lights in the sensor MUST BE ON.
-
If the leds don’t light up, adjust the sensor’s horizontal position (correct distance to the pin is
approx. 3 mm).
-
Tighten the two nuts, DO NOT OVERTIGHTEN.
-
The sensor must not touch the pin.
-
After adjusting ensure the led lights in the sensor will go OFF when the boom is lowered in the
transport support.
Figure 30: Lower boom transport support
The upper transport support sensor is located in front of the platform near the top of the linkage piece.
It is protected by a protective plate and it is not visible from the platform (Figure 31). The sensor is
adjusted according to the instructions above.
Figure 31: Upper transport support sensor
1
