SET HOUSE ID
All Miro wireless devices installed in the same home must acquire the same
unique House ID before use. This process is known as house binding. Each Miro
wireless device is bound to all other Miro wireless devices in the house.
New Installation
1. With all devices installed and
energized, make sure that
every Miro wireless device
LED is yellow. If any LED
is off, be sure the circuit
breaker is on and the device
is correctly installed.
2. Press on any device paddle
or the up and down arrows
on a Miro wireless plug-in
module until the LED fl ashes
yellow (about 2 seconds). This
indicates that it has acquired
a unique House ID.
3. Make sure that all other Miro wireless device LEDs are fl ashing green,
indicating that they have acquired the same House ID.
4. Return to the device used in step 2, which is still fl ashing yellow.
Press until the LED changes to solid green (about 2 seconds). All device
LEDs in the House change to solid green, indicating house binding is complete.
Adding a Device to an Existing Installation
If you’re adding or replacing a device in a Miro wireless installation that is already
operating, the new device must acquire the same House ID as the other Miro
wireless devices in the house. After the new device is powered up, the LED should
be solid yellow. This indicates that it has not yet acquired a House ID. To acquire
the House ID for the existing system:
1. Press on any
previously bound
device until its LED fl ashes yellow (about 2
seconds).
2. Verify that the newly added device LED is fl ashing green, indicating that it has
acquired the House ID.
3. Return to the
same previously bound
device used in step 1 and press until
the LED changes to solid green (about 2 seconds). All device LEDs should now
be solid green.
When you see
in the instructions,
fi rmly press and
hold both the up
and down arrow
buttons until the
LED changes
(about 2 seconds).
