Wattstopper
®
DLM - Digital IR Handheld Remote
User Guide
No: 25099 – 11/16 rev. 1
Catalog Number • Numéro de Catalogue • Número de Catálogo: LMRH-101
Country of Origin: Made in China • Pays d’origine: Fabriqué en Chine • País de origen: Hecho en China
SPECIFICATIONS
Power Supply ....3 AAA batteries, 1.5V alkaline or NiMH rechargeable
Environment:
Operating Temperature .............................
32˚to 95°F (0˚to 35°C)
Storage Temperature ............................
23 to 176°F (-5° to 80°C)
Relative Humidity ..............................
5 to 95% (non condensing)
Other:
RoHS compliant
FCC part 15
This device complies with Part 15 of the FCC Rules. Operation is
subject to the following two conditions: (1) this device may not cause
harmful interference, and (2) this device must accept any interference
received, including interference that may cause undesired operation.
Mounting
Holster
Handheld
Remote
DESCRIPTION
The Wattstopper LMRH-101 Digital IR Handheld Remote uses an infrared (IR) transmitter to send commands to a Digital Lighting
Management (DLM) network. It allows the user to turn lights
ON/OFF
and dim without going to a wall box device.
The LMRH-101 operates on three AAA batteries. It communicates wirelessly with other DLM devices by sending an IR signal to a DLM
IR enabled device within its range and line of sight.
Battery Installation
The battery compartment holds three standard 1.5V AAA Alkaline batteries (supplied). Rechargeable NiMH batteries can be used. Do
not mix battery types. Do not mix old batteries with new batteries.
OPERATION
The LMRH-101 uses IR technology to wirelessly send control
signals to the DLM system. Point the handheld remote at any
IR-enabled DLM device within its range and press a button to send
signals to the DLM network. To identify an IR-enabled device, look
for a dark translucent lens on the face of the device.
Transmitting Range
Please refer to the top two pictures on the right.
Default Functionality: Plug n’ Go™ (PnG)
As shipped from the factory, the rocker paddle controls all loads on
the DLM local network. To change the loads that are controlled by
the LMRH-101 see the ADJUSTMENT section.
Button Functions
Press the top of the rocker paddle to turn load(s)
ON
. The blue LED
on the paddle also turns
ON
. Switched loads turn
ON
. Dimmable
loads turn
ON
to the last light level set before they turned
OFF
.
Press the bottom of the rocker paddle to turn load(s)
OFF
.
Dimmable loads ramp down or up in response to pressing and
holding the top or bottom of the paddle.
ON/OFF
loads turn
OFF
when the ramp level dims below 50%, and turn
ON
when the ramp
level rises above 50%.
Battery Life
To conserve battery life, the LMRH-101 shuts down 5 seconds after
the last key press unless the LMRH-101 and the DLM local network
is in configuration mode (Push n’ Learn, PnL).
40°
32’
(10m) max.
32’ (10m) max.
IR Lens
• Single tap: Bound
loads turn ON to
last light level
• Press and hold:
Raise light level
• Single tap: Bound
loads OFF
• Press and hold:
Lower light level
Point at
DLM Device
Configuration
Button
Red LED
