Put the EasyUSB Mixer/Amp in firmware update mode:
1. Disconnect power from the EasyUSB Mixer/Amp
2. Set DIP Switch 8 to the UP position (firmware update mode).
3. Reconnect power and wait for the unit to finish its power-up sequence. The EasyUSB Mixer/Amp is
now ready to update.
Install the update:
1. From the product drop-down menu of Vaddio Loader, select EasyUSB Mixer/Amp.
2. Choose ‘Select Load File’ and browse to the firmware you downloaded.
3. Select Start. The squares in the bottom right corner flash and the progress bar on the bottom starts to
fill in. The update takes a few minutes.
Caution
Do not disconnect any cables until Vaddio Loader indicates a successful firmware load.
When the Vaddio Loader displays the message "Firmware Load and Install Successful", the update is
complete.
Return the equipment to its normal operating state:
1. When all updates are complete, disconnect power from the EasyUSB Mixer/Amp.
2. Set DIP Switch 8 to the DOWN position (normal operation).
3. Disconnect the EasyUSB Mixer/Amp from the computer, and reconnect all equipment in its usual
configuration.
Complete Manual for the EasyUSB Mixer/Amp Audio Mixer and Amplifier
11
