Connecting the Microphone Drop Cable
1. Remove the cover from the ceiling box.
2. Determine the desired length of the microphone drop cable, from the ceiling to the top of the
microphone body (not the top of the strain relief boot). Be sure this leaves enough cable inside the
ceiling box to avoid placing tension on the connector.
Note
If desired, you can use a Cat-5e cable made to the desired length (not to exceed 15 ft or 4.6 m) for the
microphone drop-down cable. Please contact Vaddio Technical Support if your installation requires a
longer drop cable. Cat-5e or better SSTP cable may provide better performance in some electrically
noisy environments.
3. Thread the drop cable through the opening in the floor of the box.
4. Snap the strain relief grommet onto the drop cable at the desired cable length,
and press it into the opening in the floor of the box.
5. Connect the drop cable to the port labeled MIC CABLE.
6. If there is excess cable above the grommet, thread a zip tie through the tie loop in
the side of the box and secure the cable.
5
Complete Manual for the EasyIP CeilingMIC/AMP D Network-Connected Amplifier and Overhead Microphone