Doc No. FM0614 issue D Page 5
Registering an Enuresis Sensor onto an
Altec Response
local carer alarm unit
1. Put th
e Altec Response unit into radio device learn mode…
2. Activate the E
nuresis sensor…
3. Exit the Alte
c Response radio device learn mode…
4. Activate the Enuresis sensor and check an Enuresis alarm call is displayed on the Altec Response unit.
Deleting an Enuresis Sensor from an
Altec Response
local carer alarm unit
Press
ENTER
to activate the wake-up display then
ENTER
again to display the main menu
Press
ENTER
to select
Radio Devices
Press the
key
to select
Delete Device
then press
ENTER
The display
will prompt you to “
Trigger the Sensor
”
Activate the Enuresis sensor to be deleted - the display will show the device type and its 8 digit ID number
If this is the device you activated press the
key to select
Delete
then press
ENTER
If it’s NOT the device you activated press the
ENTER
key to select
Reject
then try again
To exit the mode select
Exit
then press the
ENTER
key.
Refer to the Altec Response installation guide (Doc No. FM0548) provided with the portable alarm unit for
more information on programming and testing radio devices.
Short-out the 2 un-used metal press studs on the cotton bed sheet.
The display will show
Enuresis
and the enuresis sensor 8 digit ID number.
Check the ID is correct, press the
key to select
Accept
then
press
ENTER
.
Note: if another device has been picked-up press
ENTER
to
Reject
and try again
.
The display will show
Flat
, use the
&
keys to choose the
dwelling type.
Press the
key
to select
No: 000000
then press the
ENTER
key.
Use the
&
keys to select each digit of the flat number and
the
&
keys to move between digits then press the
ENTER
key.
Press
key
several times to select
Exit
then press the
ENTER
key.
The display will prompt you to “
Trigger the Sensor
” again.
*Note: if the enuresis sensor has been activated in
the last 15 minutes you’ll
have to reset the
MASK TIME
–
see page 2.
Press
ENTER
to activate the wake-up display then
ENTER
again to display
the main menu.
Press
ENTER
to select
Radio Devices
Press
ENTER
to select
Learn Device
The display
will prompt you to “
Trigger the Sensor
”.
You now have 20 seconds to activate the Enuresis sensor.
tynetec
tynetec
From the
Learn Device
menu select
Exit
then press
ENTER
.
From the
Radio Devices
menu select
Exit
then press
ENTER
.
The display will return to the wake-up screen and go blank after 10 seconds.
The Altec Response is now back in normal operating mode.
