Doc No. FM0462 issue F Page 4
Registering an Enuresis Sensor onto an
Advent xt
warden call system
1.
Put the Advent xt system into radio device learn mode…
2. Activate the Enuresis sen
sor…
3.
Exit the Advent xt system radio device learn mode…
4. Activate the Enuresis sensor and check an Enuresis alarm call is reported on the warden call system.
Deleting an Enuresis Sensor from an
Advent xt
warden call system
Press the
LINE
key and wait for the “
Ready
” prompt.
Enter
5 0 0 1
followed by the
key.
Enter the flat number the Enuresis sensor is being deleted from followed by the
key.
Activate the Enuresis sensor to be deleted.
W
ait for the “
Pendant Disabled
–
Enter Flat
” prompt.
Press the
#
key and wait for the “
Ready
” prompt
, then press the
LINE
key to clear the connection.
Refer to the Advent xt
operator’s
manual (Doc No. FM0420) provided with the warden call system for more
information on programming and testing radio devices.
Using the Manager’s DECT telephone;
Press the
LINE
key and wait for the “
Ready
” prompt.
Enter
5 0 0 0
followed by the
key.
Enter the flat number the Enuresis sensor is being installed in
followed by the
key.
You now have 1 minute to activate the Enuresis sensor.
“
Ready”
Using the Manager’s DECT telephone;
Press the
#
key and wait for the “
Ready
” prompt.
Press the
LINE
key to clear the connection and the warden call system is
now back in normal operating mode.
“
Ready”
Place a damp cloth on the plastic bed mat.
Wait
for the “
Enter Location Code
” prompt
then press
0
(no
location) followed by the
key.
W
ait for the “
Pendant Enabled
–
Enter Flat
” prompt.
*Note: if the Enuresis sensor has been activated in the last 15
minutes you’ll have to reset the
MASK TIME
–
see page 2.
