Doc No. FM0855 issue 2 Page 16
13. LAPTOP SETUP FOR DRAYTEK DEVICES
Before starting to setup the Mesh Access Points you must ensure your Laptop is set within the IP range and
subnet mask of the Draytek devices being programmed.
1.
On your Laptop; click the
Start button, go to Control Panel and double-click on
“
Network and
Sharing Center
”
. Then select the
“
Change adapter settings
” and click “Local Area Connection”.
2.
Right-click and select
“
Properties
”
of the LAN Network Port that will be used.
3.
Select the
“
Internet Protocol Version 4 (TCP/IPv4)
”
and select
“
Properties
”
as shown below;
4.
Enter the
IP address
Subnet mask
Default gateway
as shown here…
5.
Press the Advanced button.
6.
Press Add and enter a second IP address and Subnet mask as shown below. This sets both ranges
that maybe needed for accessing the required IP addresses.
*
Note: if your Laptop is set to “obtain IP address automatically” you will have
to change this setting back
once the programming is complete.
*See note below