LEGRAND Raritan SRC-0100, User Manual

Page: 534 / 698

Chapter 8: Using the Command Line Interface
522
-- OR --
# reset factorydefaults /y
To reset SRC settings before login:
Username: factorydefaults
See
Using the CLI Command
(on page 584) for details.
Note: Device reset will cause CLI communications over an "USB"
connection to be lost. Therefore, re-connect the USB cable after the
reset is complete.
Network Troubleshooting
The SRC provides 4 diagnostic commands for troubleshooting network
problems:
nslookup, netstat, ping, and traceroute. The diagnostic
commands function as corresponding Linux commands and can get
corresponding Linux outputs.
Entering Diagnostic Mode
Diagnostic commands function in the diagnostic mode only.
To enter the diagnostic mode:
1. Enter either of the following modes:

Administrator mode: The # prompt is displayed.

User mode: The > prompt is displayed.
2. Type
diag
and press Enter. The diag# or diag> prompt appears,
indicating that you have entered the diagnostic mode.
3. Now you can type any diagnostic commands for troubleshooting.
Quitting Diagnostic Mode
To quit the diagnostic mode, use this command:
diag> exit
The # or > prompt appears after pressing Enter, indicating that you have
entered the administrator or user mode. See
Different CLI Modes and
Prompts
(on page 377).