Chapter 8: Using the Command Line Interface
519
Example 2 - Combination of SSID and PSK Parameters
This multi-command syntax configures both SSID and PSK parameters
simultaneously for the wireless feature.
config:#
network wireless SSID myssid PSK encryp_key
Results:
The SSID value is set to myssid.
The PSK value is set to encryp_key.
Actuator Control Operations
An actuator, which is connected to a dry contact signal channel of a
Raritan sensor package, can control a mechanism or system. You can
switch on or off that mechanism or system through the actuator control
command in the CLI.
Perform these commands in the administrator or user mode. See
Different CLI Modes and Prompts
(on page 377).
Switching On an Actuator
This command syntax turns on one actuator.
#
control actuator <n> on
To quicken the operation, you can add the parameter "/y" to the end of
the command, which confirms the operation.
#
control actuator <n> on
/y
Variables:
<n> is an actuator's ID number.
The ID number is available in the SRC web interface or using the
show command in the CLI. It is an integer starting at 1.
If you entered the command without "/y", a message appears, prompting
you to confirm the operation. Then:
Type
y
to confirm the operation, OR
Summary of Contents for Raritan SRC-0100
