LEGRAND Raritan SRC-0100, User Manual

Page: 35 / 698

Chapter 3: Initial Installation and Configuration
23
Note: The blue Cisco RJ-45 to DB9 adapter cable CANNOT be used for
connecting a modem. See
RJ45-to-DB9 Cable Requirements for
Modem Connections
(on page 637).
Bulk Configuration Methods
If you have to set up multiple SRC devices, you can use one of the
following configuration methods to save your time.
A bulk configuration file downloaded from SRC:

Requirement: All SRC devices to configure are of the same model
and firmware.

Procedure: First finish configuring one SRC. Then download the bulk
configuration file from it and copy this file to all of the other SRC
devices.
See
Bulk Configuration
(on page 330).
A TFTP server:

Requirement: DHCP is enabled in your network and a TFTP server is
available.

Procedure: Prepare special configuration files, which must include
fwupdate.cfg, and copy them to the root directory of the TFTP server.
Re-boot all SRC devices after connecting them to the network.
See
Bulk Configuration or Firmware Upgrade via DHCP/TFTP
(on
page 554).
Curl command:

Requirement: Two files are required -- one is a configuration file in
TXT and the other is a devices list file in CSV. See
config.txt (on page
546) and
devices.csv
(on page 549).

Procedure: Upload both files to all of SRC devices one by one, using
the appropriate curl command.
See
Upload via Curl
(on page 580).
SCP or PSCP command:

Requirement: Two files are required -- one is a configuration file in
TXT and the other is a devices list file in CSV.

Procedure: Upload both files to all of SRC devices one by one, using
the appropriate SCP or PSCP command.
See Uploading or Downloading Raw Configuration Data (on page
531).