LEGRAND Raritan PX3TS, User Manual

Page: 35 / 911

Chapter 3: Initial Installation and Configuration
15
▪
Connect a USB hub to the USB-A port on the PX3TS. Then plug the
supported USB wireless LAN adapter into the appropriate USB port on
the hub.
See USB Wireless LAN Adapters (on page 15) for a list of supported
wireless LAN adapters.
USB Wireless LAN Adapters
The PX3TS supports the following USB Wi-Fi LAN adapters.
Wi-Fi LAN adapters Supported 802.11
protocols
SparkLAN WUBR-508N A/B/G/N
Proxim Orinoco 8494 A/B/G
Zyxel NWD271N B/G
Edimax EW-7722UnD A/B/G/N
TP-Link TL-WDN3200 v1 A/B/G/N
Raritan USB WIFI A/B/G/N
Supported Wireless LAN Configuration
If wireless networking is preferred, ensure that the wireless LAN configuration
of your PX3TS matches the access point. The following is the wireless LAN
configuration that the PX3TS supports.
▪
Network type: 802.11 A/B/G/N
▪
Protocol: WPA2 (RSN)
▪
Key management: WPA-PSK, or WPA-EAP with PEAP and MSCHAPv2
authentication
▪
Encryption: CCMP (AES)
Tip: Supported 802.11 network protocols vary according to the wireless LAN
adapter being used with the PX3TS. See
USB Wireless LAN Adapters (on page
15).
Note: You must configure PX3TS to enable its wireless LAN interface. See the
topic titled
Configuring Network Settings (on page 310) in the User Guide.