LEGRAND Raritan PX3-3000 Series, User Manual

Page: 556 / 977

Chapter 8: Using the Command Line Interface
535
Displayed information:

Without the parameter "details," only the reading, state, threshold,
deassertion hysteresis and assertion timeout settings of the
specified inlet sensor are displayed.

With the parameter "details," more sensor information is displayed,
including resolution and range.

If the requested sensor type is not supported, the "Sensor is not
available" message is displayed.
Additional sensors supported by specific models:
Specific PX3 models support some or all of the following sensors. The
CLI command(s) listed above can be also applied to the following sensors.
Note that the measurement unit of current values in CLI is A, not mA.
Sensor type Description
peakCurrent Peak current sensor
reactivePower Reactive power sensor
displacementPowerFa
ctor Displacement power factor sensor
residualCurrent RCM current sensor

For Type A, it is the sensor that detects
residual AC current.

For Type B, it is the sensor that detects
both residual AC and DC current.
residualDCCurrent RCM DC current sensor - detects residual
DC current only.
Available only on PDUs with RCM Type B.
Note: For information on RCM Type A and B sensors, see RCM Current
Sensor
(on page 797).