Call 800.223.4185 for Technical Support
ADVANCED OPERATION
Assigning Occupancy Emulation to a House Scene
You can assign the repeater’s occupancy emulation function to a LightSense™
House Scene button. This is very convenient, especially if the repeater is
installed in a hard to reach area.
1. From a wireless house scene controller (PSWCH or PSWRH), press
until
its LED begins flashing (about 2 seconds).
2. Press the scene button you want to use. We recommend the fourth one. The
LEDs on all the LightSense wireless devices begin to flash. You now have
10 minutes to complete this process.
3. Go to the repeater and press both buttons for 2 seconds until the repeater
status LED blinks yellow.
IMPORTANT
: Only one repeater should be assigned to the house scene
button. If you have more than one repeater, use the most centrally located.
4. Check all the LightSense wireless device LEDs. If they are blinking yellow,
they are assigned to the selected scene button. To exclude a device from
the scene press
on the device until the LED begins to flash green.
Yellow
flashing LED = Included in the active scene
Green
flashing LED = NOT included in the active scene
If you get to a device and its LED is NOT flashing, the 10 minute binding
process timer may have expired. Go back to step 1 and repeat.
5. Return to the house scene controller used in step 1. Press
for 2 seconds
– the status LED stops flashing, then all the status LEDs in the house turn to
solid green.
6. From the same house scene controller, press and hold the same scene
button until the LED flashes once (about 2 seconds). Scene recording for
this button is complete.
7. When you leave the house, press the House Scene button you just
recorded. One minute later, occupancy emulation will begin.
