11
Two options for programming your remote control:
- manual entry of the code (recommended),
- automatic search.
Manual entry of the code
Step 1: insert the batteries respecting the polarity,
Step 2: set the dial to TV mode,
Step
3
: switch on your TV (do not leave the TV on standby),
Step 4: press the function button
and hold it until the indicator light flashes twice (about 2 seconds),
Step 5: enter the code selected from the booklet within 5 seconds,
Step 6: the indicator light flashes twice to confirm correct entry of the code,
Step 7: check the correct operation of your remote control by pressing the
button (ON/OFF).
If your TV does not respond go to the next code in the list and repeat the process from step
3
.
Automatic search
Step 1: switch on your TV (do not leave the TV on standby),
Step 2: set the dial to TV mode,
Step
3
: press the function button
and hold it until the indicator light flashes twice (about 2 seconds),
Step 4: enter the code 0001 (within 5 seconds). The indicator light flashes again twice to confirm entry
of the code.
Step 5: hold down the
ON/OFF button (within 5 seconds) until your TV switches off.
During the search the LED flashes every two seconds.
The first code found is not always the right one.
Step 6: to save the code in your remote control, press the
button until the LED flashes double.
Reading the automatic search
In order to facilitate re-programming of your remote control the result of the automatic search can be read,
by proceeding as follows:
Step 1: set the dial to TV mode
,
Step 2: press and hold the
button until the LED flashes double,
Step
3
: enter the code 0002 (within 5 seconds), the LED flashes double to confirm that your remote control is
“in read mode”,
Step 4: to read the saved code, press on the following buttons:
To find out the corresponding figure, count the number of times the LED flashes while you press the button.
For the fir
s
t fig
u
re (tho
usa
nd
s
)
For the
s
econd fig
u
re (h
u
ndred
s
)
For the fo
u
rth fig
u
re (
u
nit
s
)
For the third fig
u
re (ten
s
)
Important:
The TV manufacturer may not be in the code list or none of the manufacturer codes given in the list may
correspond to your TV.
In this case we recommend you start an automatic search.
Be patient, there are many codes and the search can last up to 15 minutes.
