Lock House Configuration
The Lock Configuration function operates from a wireless Miro house scene
controller, and prevents the Miro wireless devices in the system from being
reprogrammed. Normal operations such as dimming, switching, scene recall and
scene light level modifications are not affected.
When the configuration is locked, if the rocker paddle on any Miro wireless
device is pressed and held (- -), the selected device’s LED flashes red, and the
command is ignored.
To lock the configuration:
Go to any house scene controller. Simultaneously press and buttons
B
and
E
for 2 seconds to toggle in and out of Lock Configuration mode.
• If the mode changes from unlocked to locked, the LED flashes red for 2
seconds, indicating that configuration is now locked.
• If the mode changes from locked to unlocked, the LED flashes green for
2 seconds, indicating that configuration is now unlocked.
CLEaning
Clean using a cloth dampened only with water and a little mild detergent. Use of
solvents or hydrocarbon-based cleaners may cause permanent damage.
TRouBLESHooTing
During Set House iD, the LED is not flashing on some Wireless Miro
devices.
•
if LED is solid green before initiating House iD binding:
The device already has another House ID. Reset it to the factory default so
that it can be bound to the desired House ID. Resetting to factory defaults is
described in the “I need to start over” issue.
•
if LED is solid yellow after initiating House iD binding:
The device may be out of range of the initiating device. Add a MRR2G Wire-
less Miro Repeater to boost signal range.
i made a configuration mistake. i need to start over.
You can reset any wireless Miro device to factory default settings by press-
ing and holding until the LED changes to solid yellow (approximately 10
seconds). During the process, the LED flashes yellow and when complete,
it changes to solid yellow. The device can then be reconfigured, exactly like
any new device.