Installation Instructions
PACFAN1
3
PARTS FOR INSTALLATION
A (1)
[Kiosk fan]
B (1)
[12V Adaptor]
ASSEMBLY AND INSTALLATION
NOTE:
The PACFAN1 fan accessory can be used with all
Chief™ Portrait Wall Kiosk mounts between 43" and
75" (Models LW43/46/47/48/49/55/65/70/75xUP).
1.
Remove adhesive covers from four foam tape squares on
outer edges of kiosk fan (A) . (See Figure 1)
Figure 1
2.
Use four foam tape squares to attach kiosk fan (A) to a clean
surface along top edge of kiosk making sure it’s installed in
a position so that there is enough clearance for the door to
shut. (See Figure 2)
Figure 2
3.
Connect fan cables to available power source using 12V
adaptor (B).
Automatic "On/Off" Feature
IMPORTANT ! :
The PACFAN1 is designed to only run
when the internal temperature reaches 87° F or higher
and will turn off automatically when the temperature
drops below 85°. This feature may be turned "off" by
adjusting the switch located on the control box.
1.
To turn "off" temperature sensors, remove jumper from
control box pins. (See Figure 3)
2.
Install removed jumper to the far right position to the "fans
on" position and the fans will run continuously regardless of
temperature. (See Figure 3)
Figure 3
1
x 4
(A)
(A)
2
allow room
for clearance
2
(LW46 shown as example)
jumper in default
position
control box
jumper in "fan on"
position
1
2
