4/16
ELIOT Kit STOP&GO Connected
Cat. N°: 4
149 54
4. PREPARATION - CONNECTION
(continued)
Recommended tools:
. For the terminals of the Stop&Go: flat screwdriver 3,5 mm.
. For the terminals of the Supply modules: Pozidriv n°1 or flat
screwdriver 4 mm.
. For fixing: flat screwdriver 5.5 mm (6 mm maximum).
Conductor type:
. Copper cables
. Stop&Go
Without ferrule
With ferrule
Rigid cable
1 x 2,5 mm²
2 x 1,5 mm²
-
Flexible cable
1 x 2,5 mm²
2 x 1,5 mm²
1 x 2,5 mm²
2 x 1,5 mm²
. Supply module
Without ferrule
With ferrule
Rigid Cable
1 x 1,5 mm²
2 x 1,5 mm²
-
Flexible Cable
1 x 1,5 mm²
2 x 1,5 mm²
1 x 1,5 mm²
2 x 1
,5 mm²
Kit assembling:
1. - 2. Connect Power supply module and Wi-Fi interface with the
250 mm Supply patch cords.
3.
Connect Wi-Fi interface and Stop&Go with the pre-cabled 1 m
length cable in the dedicated port of the Stop&Go
Note: the length of 1m allows to clip the Wi-Fi module (and the
power supply) on a different DIN row, than the Stop&Go module.
4. PREPARATION - CONNECTION
(continued)
Diagnostic procedure:
. Once the kit assembly and the electrical connections have been
made, it is advisable to carry out a diagnostic procedure to check the
good communication between the Stop&Go module and the Wi-Fi
interface.
. Necessary material:
- kit Stop&Go
- smartphone with a Wi-Fi connexion
. Procedure:
1. Close the Stop&Go via the two handles (iso power
upward)
2. Put the Wi-Fi interface in configuration mode pressing the fron
face button for about 7 seconds, until the
“
Wi-F
i”
LED flashes rapidly
in orange.
The interface is now in programming mode and it creates its own
network (S&G_WIFI_xxxxx)
3. Connect the smartphone to the Wi-Fi network created by the
interface (network: S&G_WIFI_xxxxx)
4. Open a web browser page and enter the IP address
192.168.1.1 to connect to the diagnostic web page of the Wi-Fi
interface and pr
ess “START TEST”
Technical data sheet: F02465EN/01
Updated: 28/03/2019
Created: 06/10/2016
