31
30
Burglar-alarm unit 3486
User manual
How many times should calls be made?
About your remaining credit
GSM MANAGEMENT
PIN code
Check credit
SMS activation
DIAL NUMBER
call
SELECT
Antitheft
Communicator
COMMUNICATOR
Set calls
Vocal messages
Tel. functions
GSM management
Accessing the Dialling device (communicator) menu
and select GSM management
ANTIFURTO
Memoria eventi
Data e ora
Comandi
Automazioni
ANTIFURTO
Scenari
Zone
Dispositivi
Memoria eventi
SELEZIONARE
Antifurto
Comunicatore
AUTOMAZIONI
1
:
Automazione 1
2
: Automazione 2
3: Automazione 3
Disabilita
AUTOMAZIONI
1
:
Automazione 1
2
: Automazione 2
3:
Automazione 3
Abilita
AUTOMAZIONI
1
:
Automazione 1
2
: Automazione 2
3
:
Automazione 3
Disabilita
Press
to enter
GSM MANAGEMENT
PIN code
Check credit
SMS activation
DIAL NUMBER
call
SELECT
Antitheft
Communicator
COMMUNICATOR
Set calls
Vocal messages
Tel. functions
GSM management
Select Check credit
ANTIFURTO
Memoria eventi
Data e ora
Comandi
Automazioni
ANTIFURTO
Scenari
Zone
Dispositivi
Memoria eventi
SELEZIONARE
Antifurto
Comunicatore
AUTOMAZIONI
1
:
Automazione 1
2
: Automazione 2
3: Automazione 3
Disabilita
AUTOMAZIONI
1
:
Automazione 1
2
: Automazione 2
3:
Automazione 3
Abilita
AUTOMAZIONI
1
:
Automazione 1
2
: Automazione 2
3
:
Automazione 3
Disabilita
Press
to enter
GSM MANAGEMENT
PIN code
Check credit
SMS activation
DIAL NUMBER
call
SELECT
Antitheft
Communicator
COMMUNICATOR
Set calls
Vocal messages
Tel. functions
GSM management
Dial the number given by the telephone carrier and
press
to enter
This will go on for the number of set cycles (max 4).
If the MyHOME_Web portal or the Ademco protocol are active, the jolly number will be that of the
portal or the surveillance unit.
Both PSTN (fixed line) and GSM channels are enabled in the basic configuration; calls will be made,
according to the number of set cycles, on one channel first and then on the other by following the
priority programmed by the installation technician.
•
Have not answered the first call.
•
Were busy when the call was made.
•
Have answered the call but the person who answered did not press a number when requested
by the Unit.
Once the Unit starts making calls after an alarm, it starts operating as follows:
It calls the jolly number first;
then, it calls the set telephone numbers in the ordered sequence for that specific alarm (see
Chapter “Setting up the calls”); 20 seconds elapse between one call and the other.
When the first call cycle has been completed, it starts again with the second cycle (if set); the next
cycle will only call the telephone numbers that:
If you use a prepaid SIM card, it is possible to know the remaining credit with the following
procedure:
WHAT MUST NOT BE DONE:
– Never unscrew the antenna connector!;
– Do not remove the SIM Card!
If you need help, call your installation technician!