G-SMR-2 Custom Remote Control Operation Guide 99300822-e
7
g-smr-2 custom remote controL programming
(2 remote controls - 1 base)
OPERATE ONLY ONE (1) REMOTE CONTROL
AT A TIME. OPERATING TWO (2) REMOTE
CONTROLS AT THE SAME TIME WILL
MOMENTARILY BLOCK BOTH RF SIGNALS
AND PREVENT BOTH CONTROLS FROM
FUNCTIONING.
note
step 3
Repeat Step 1 and Step 2 with remote control 2.
Two remote controls are now programmed to
operate one base.
REMOTE
CONTROL 1
REMOTE
CONTROL 2
FIGURE 2: Power down box, AC J box and DC motor.
LEARN
BUTTON
POWER
DOWN BOX
AC J BOX
POWER DOWN
BOX (NOT
MOUNTED TO
BASE FRAME)
AC J BOX
(MOUNTED
TO BOTTOM
SIDE OF BASE
FRAME)
LEARN
BUTTON
DC MOTOR-NO
POWER DOWN
BOX
DC MOTOR
(MOUNTED TO
BOTTOM SIDE OF
BASE FRAME)
a
b
c
Program Two Remotes to Operate One Base
- your
adjustable base will be equipped with one of the
following: (A) a DC motor with a power down box,
(B) an AC J box, (C) a DC motor without a power
down box (
FIGURE 2
).
step 1
(A) DC motor with a power down box:
press
the learn button on the power down box for 1
second.
(B or C) AC Jbox
or
DC motor without power
down box:
unplug the adjustable base electrical
power cord. Wait 30 seconds, then plug the
cord back into the power source.
step 2
On the remote control, simultaneously press
and hold the
POS 1
and
head massage on/off
buttons
(
FIGURE 3
).
The transmission indicator
light will
flash slowly
and then
flash rapidly
to
indicate programming mode.
Continue to hold
for 5 seconds and then release the buttons.
POS 1
BUTTON
HEAD
MASSAGE
ON/OFF
BUTTON
TRANSMISSION
INDICATOR LIGHT
FIGURE 3
