Mounting the seats (Fig. 5)
On the left side insert the seating tube into the hole of the wheel holder intended for this.
Now, by pulling back the pin, on the right side it is possible to clip the seating tube into
the hole for this in the wheel holder housing. Take care to ensure that it clips in properly.
Fasten the seats at the back using the snap fasteners on the holding belts.
Then fasten the seat belts at the top (Fig. detail) around the rollbar and lash them tightly.
Take care to ensure that the belts are tightly fastened.
Take care to ensure that the settings of the five-point belts are adjusted suitably corre-
sponding to the age of the child (Fig. 2, page 43)
Warning: Seat tube must not be inserted inclined.
Rear
Now close the rear using the cover for this and the appropriate fastening rings.
3
4
5
6
Fig. 5
3