Renegade Cluster - Installation
Ground (black)
+12 volts Dash lighting (white)
Snap connection for dial lighting
+12 Volts
(#14 Red)
(#15 Black)
Ground
(#13 White)
+12 Volts Dash lighting
Power distribution cable
(#3 Green/Orange)
(#5 Green/Red)
(#1 Blue/White)
left turn 12V pulse
right turn 12V pulse
high beam wire +12V
Inverter
GPS Hot Start (#8 Red/Black Wire)
Connect to +12VDC non-
.
(25 micro-amp draw) See
Figure 8
GPS Antenna (See
Figure 8
)
INVERTER IS REQUIRED FOR GAUGE DIAL LIGHTING
(Pointer (needle) lighting)
(Main gauge power)
(Gauge Dial lighting)
Dial Lighting Inverter Note: Single EL dial lighting inverter included with individual gauge.
Multi-gauge EL dial inverter included with gauge set of 3 to 8 gauges.
***Protect any unused connectors. Damage to an unused connector could cause inverter failure.***
Fuel level signal (#10 Pink)
Tachometer Signal (#17 Yellow Wire)
(Available on some models)
Attach to included wire harness and connect to Tachometer signal out (See
Figure 9
)
Brake Light [GND] (#7 Black)
Fuel Level Ground Wire (#9 Yellow/Black)
4X4 Indicator [GND] (#11 Orange)
Water Temperature Signal (#12 Yellow/Red)
Water Temperature Ground (#16 Yellow/Black)
(Wire Pair CAN high #4 and CAN low #6)
OBDII
(See Figure 7 for details)
(Wire Pair #18 and #19)
Snap connection
Note: Tie together the +12VDC
dash lighting wire (#13 white) to
the +12VDC inverter white wire
and connect to the same dash
lighting source.
Snap connection
FIGURE 3: Connection Guide
See Figure #2 for more wiring information and numbering.
Speed signal (#2 Red/Green)
Connect to Speed Sender (See
Figure 4
)
- 3 -
Check Engine [GND]
(#20 Purple Wire)
Attach to included wire harness and connect to Fuel Level Sender (See
Figure 5
)
Attach to included wire harness and connect to Temperature Sender (See
Figure 6
)
Power Draw = 0.2 Amp
3A to 5A Inline Fuse Recommended
for +12