Step 11:
Ensure that the cables can reach the desired light locations, then
secure them to the vehicle side frame and ceiling cross beams using your
preferred method. Legend recommends tuck tape or similar.
Step 12:
Install ceiling liner, if applicable.
Step 13:
Unplug the feed loom from the rest of the circuit. This will make sure
the lights stay off while you are installing them, which will be easier on your
eyes.
Step 14:
Connect the Dome Lights to the Rappid cables. Ensure that the
housings have clicked together.
Step 15:
Re-attach the feed loom to the circuit. The lights should power on.
If they do not,
check that the fuse has been inserted into the feed loom; if
fuse is properly installed,
refer to the troubleshooting guide on page 3
6
.
WARNING:
The lights are very bright and may cause temporary blindness if
looked at directly for short durations.
When plugged in, the light will turn on
and remain lit for 3 seconds, then turn off.
Legend Light Kit Install Guide v2.2
Page 34 of 36